Atomic layer deposition of vanadium oxide films for crystalline silicon solar cells.

Transition metal oxides (TMOs) are promising materials to develop selective contacts on high-efficiency crystalline silicon solar cells. Nevertheless, the standard deposition technique used for TMOs is thermal evaporation, which could add potential scalability problems to industrial photovoltaic fabrication processes. As an alternative, atomic layer deposition (ALD) is a thin film deposition technique already used for dielectric deposition in the semiconductor device industry that has a straightforward up scalable design. This work reports the results of vanadium oxide (V2O5) films deposited by ALD acting as a hole-selective contact for n-type crystalline silicon (c-Si) solar cell frontal transparent contact without the additional PECVD passivating layer. A reasonable specific contact resistance of 100 mΩ cm2 was measured by the transfer length method. In addition, measurements suggest the presence of an inversion layer at the c-Si/V2O5 interface with a sheet resistance of 15 kΩ sq-1. The strong band bending induced at the c-Si surface was confirmed through capacitance-voltage measurements with a built-in voltage value of 683 mV. Besides low contact resistance, vanadium oxide films provide excellent surface passivation with effective lifetime values of up to 800 µs. Finally, proof-of-concept both-side contacted solar cells exhibit efficiencies beyond 18%, shedding light on the possibilities of TMOs deposited by the atomic layer deposition technique.

Controlling the Anionic Ratio and Gradient in Kesterite Technology.

Accurate anionic control during the formation of chalcogenide solid solutions is fundamental for tuning the physicochemical properties of this class of materials. Compositional grading is the key aspect of band gap engineering and is especially valuable at the device interfaces for an optimum band alignment, for controlling interface defects and recombination and for optimizing the formation of carrier-selective contacts. However, a simple and reliable technique that allows standardizing anionic compositional profiles is currently missing for kesterites and the feasibility of achieving a compositional gradient remains a challenging task. This work aims at addressing these issues by a simple and innovative technique. It basically consists of first preparing a pure sulfide absorber with a specific thickness followed by the synthesis of a pure selenide part of complementary thickness on top of it. Specifically, the technique is applied to the synthesis of Cu2ZnSn(S,Se)4 and Cu2ZnGe(S,Se)4 kesterite absorbers, and a series of characterizations are performed to understand the anionic redistribution within the absorbers. For identical processing conditions, different Se incorporation dynamics is identified for Sn- and Ge-based kesterites, leading to a homogeneous or graded composition in depth. It is first demonstrated that for Sn-based kesterite the anionic composition can be perfectly controlled through the thicknesses ratio of the sulfide and selenide absorber parts. Then, it is demonstrated that for Ge-based kesterite an anionic (Se-S) gradient is obtained and that by adjusting the processing conditions the composition at the back side can be finely tuned. This technique represents an innovative approach that will help to improve the compositional reproducibility and determine a band gap grading strategy pathway for kesterites. Furthermore, due to its simplicity and reliability, the proposed methodology could be extended to other chalcogenide materials.

How optical excitation controls the structure and properties of vanadium dioxide.

We combine ultrafast electron diffraction and time-resolved terahertz spectroscopy measurements to link structure and electronic transport properties during the photoinduced insulator-metal transitions in vanadium dioxide. We determine the structure of the metastable monoclinic metal phase, which exhibits antiferroelectric charge order arising from a thermally activated, orbital-selective phase transition in the electron system. The relative contribution of the photoinduced monoclinic and rutile metals to the time-dependent and pump-fluence-dependent multiphase character of the film is established, as is the respective impact of these two distinct phase transitions on the observed changes in terahertz conductivity. Our results represent an important example of how light can control the properties of strongly correlated materials and demonstrate that multimodal experiments are essential when seeking a detailed connection between ultrafast changes in optical-electronic properties and lattice structure.

A photoinduced metal-like phase of monoclinic VO2 revealed by ultrafast electron diffraction.

The complex interplay among several active degrees of freedom (charge, lattice, orbital, and spin) is thought to determine the electronic properties of many oxides. We report on combined ultrafast electron diffraction and infrared transmissivity experiments in which we directly monitored and separated the lattice and charge density reorganizations that are associated with the optically induced semiconductor-metal transition in vanadium dioxide (VO2). By photoexciting the monoclinic semiconducting phase, we were able to induce a transition to a metastable state that retained the periodic lattice distortion characteristic of the semiconductor but also acquired metal-like mid-infrared optical properties. Our results demonstrate that ultrafast electron diffraction is capable of following details of both lattice and electronic structural dynamics on the ultrafast time scale.